Na šta treba obratiti pažnju tokom pre montaže cevovoda I
1. Overview of pipes
(1) Double line main pipe and branch pipe: from the lubrication pump out to the oil inlet of all the distributor, the pressure is relatively high. It is usually cold drawn seamless steel pipe made of 10 or 15 gauge steel. Never use badly rusted pipes;
(2) Feed pipe: from the distributor to all lubricating point inlet (bearing seat oil hole), the pressure is relatively low. Usually drawn copper pipe is used for easy piping when bending. There are also cold-drawn seamless steel pipe or stainless steel pipe;
(3) The rubber hosefitinge is used when the movable part is connected.
2. Zahtjevi za raspored cijevi
(1) The pipeline should try to avoid the high temperature radiation and cooling water spray temperature is too high or too low, especially the rubber hosefitinge;
(2) The piping should not affect the operation of the main engine and other equipment, and should be safe and reliable, convenient for work, observation and maintenance;
(3) the cloth pipe should be horizontal and vertical, neat and beautiful. As little as possible turning or small Angle elbow, the use of large arc, so as to reduce oil flow resistance;
(4) When the installation conflicts, the small tube should let the large tube and the low pressure tube let the high pressure tube;
(5) Pipelines should not touch each other when they cross each other, and should be separated from a certain distance;
(6) parallel pipe joints should be staggered installation, so as not to affect the installation and disassembly;
(7) In order to facilitate disassembly and cleaning, flexiblemontažas should be properly installed, but less use, to reduce the possibility of leakage.
3. Determine the length of the pipe
(1) According to the fixed piping path determined in 8.2, the length of the pipe is measured on site, and the influence of the radius of the elbow should be paid attention to;
(2) to take into account the impact of different pipefitinge after they are connected to the pipeline;
(3) The length of the pipe should be determined, cut off and pre-installed section by section to facilitate on-site adjustment according to the actual situation. If all the pipes are cut off at once, it will be difficult to assemble the pipe when errors accumulate;
(4) The cut short pipe should be used as far as possible in each place where the short pipe is needed. If necessary, the straight pipefitinge can be lengthened, but thefitinge on the pipe segment should be less than more.
4. Odrežite cijev
(1) Cut the pipe with sawing machine or special pipe cutting machine and other machines. Dissolving (such as flame cutting) or grinding wheel is never allowed to cut the pipe;
(2) The incision should be smooth, the plane of the section is not more than 1 mm, and the perpendicularity of the pipe axis is not more than 1 degree;
(3) remove chips and burrs with file and scraper;
(4) use clean compressed air or other methods to remove debris and floating rust attached to the pipe;
5. Bend the tube
(1) Cold bending, not hot bending (large diameter pipe can be replaced by right-anglefitinge), bending radius should be more than 4 times the diameter of the pipe;
(2) The ellipticity at the bend (variation of length and diameter) is less than 10% of the pipe diameter, and wrinkling is not allowed;
(3) Ako postoji amontaža at the bending end of the pipe, there should be a straight pipe connected to themontaža at the pipe end to avoid affecting the installation;